keyless entry remote programing

[tylerlisk]

Hey guys,

I tried programing my one keyless remote to my truck and nothing is happening. The light comes on on the remote when I push any of the 4 buttons (so the battery works), and also when i follow the programming method below, every thing works up until I use the remote (truck lights flash 4 times when I ground out the wire 4 times). Is my remote faulty? do you keep it grounded on the fourth ground? Anyone ever dealt with this before??







For 1998 and earlier Hummers:



The receiver can be programmed to work with up to four transmitters. To add, replace and/or delete transmitter:



1. Locate the unconnected gray wire with a pink or red connector taped to the remote entry harness connected to the receiver module beneath the console cover.



2. Assemble all the transmitters to be used.



3. Turn on the ignition switch.



4. Ground the pink-red connector four times in succession. The parking lamps will flash four times and the system will reset itself in the program mode.



5. Push the button on any transmitter and the lights will flash once.



6. Repeat this for the remaining transmitters for up to four transmitters. The above must be accomplished within 30 seconds from grounding the gray wire connector or the system will exit the programming mode and the procedure will have to be repeated.



7. Turn the ignition switch off following the above and check each transmitter for correct function.

[NorthBayH1]

Where do I get these transmitters

[dwaxman1]

check this out Austin...



Keyless transmitters

[NorthBayH1]

seems to only be for 99 and up

[dwaxman1]

[quote name='NorthBayH1' timestamp='1300560230' post='26003']

seems to only be for 99 and up

[/quote]



oops, let me find the younger one, a lot more cash, might be cheaper to buy a cheap alarm kit....



The Younger model

[tylerlisk]

[quote name='dwaxman1' timestamp='1300591693' post='26017']

oops, let me find the younger one, a lot more cash, might be cheaper to buy a cheap alarm kit....



The Younger model

[/quote]

My transmitter is the newer one. Weird!

[dwaxman1]

and it worked Tyler??

[Tom]

Here is a section from the Service manual on newer remotes.

[dwaxman1]

this is from the 96 service manual....