Daytime Running Lights

[Nuzguy]

Good Morning,



I am installing daytime running lights in the H1 I just drove from Houston to Vancouver. Can anyone tell me which wires are which at the back of the headlight? I have found high beam but I need to indentify the low beam and common.



thanks



Nuzguy

[Roy]

Normally the wires are spliced under the dash at the steering column. Did you buy the Canadian Tire DRL adapter. It is the easiest to install and fairly cheap.

[Nuzguy]

hi Roy... thanks for the reply.



yes. i bought a modul made by Hamsar from Canadian tire and it shows it being installed at the headlight.



les

[Roy]

On the steering column, near the bottom, you will find a switch that controls high/low beam.Probe the wires for power when the low beams are on. Tan wire, Aux power lead.. on the fuse box by your knees, there is power leads you can plug into, do not forfget to put a fuse in.



At the headlight, black is ground,tan is low and red is high.Colours according to the book .

you can always pull the wires off the back of the headlight pod and varify.

[Nuzguy]

thanks Roy... this did the trick! lights passed inspeciton... now need tires and a replacement CV Boot on one of the rear halfshafts.



thanks again



Nuz