Star washer seal

[Monk]

I had my pinion seal and the two side axle seals changed last year and since I have minor leaking on caliber both sides, drips but I replace every other month....

I'm more then positive they didn't install any start seal, as I remember on the three bigger ones,

I was going to try to fix, do I NEED the start washer? Or can I seal with "good stuff" sealant and let dry a few hours and then put on the shaft flange?

Or is the star washer nesessary ?

[Roy]

Are you looking for the shaft seal? little blue rubber washer with splines on the outer profile.
 
Got em.

[Monk]

Yes I WILL be ,

Yes was wondering if I can just squish sealant in there ,but probably best to just do it right and put sealant on inside and outside of the seal.. Lol cover all basis

[Roy]

If it is just the nut that is leaking, put sealant on the mounting face as a temporary fix. Then order in the right parts. Unless it is the output shafts of the diff. Then there will be too much time to do it twice.