Outfitter Design HP Dana 44 IFS bolt front diff

[citiboy]

Just want to share the awesome Outfitter Design new mods for the H3. 
 
<div>...from the forum:</div>
<div>In regards to the loss of ground clearance there are three options:</div>
<div>#1 Run the 0.75" spacers in the kit</div>
<div>#2 Notch the skid just where diff comes in contact (will be close to flush with bottom of skid plate)</div>
<div>#3 We will make a 1/4" plate skid which will fit up tight to the diff and should be almost no loss of ground clearance. </div>
 
~$3,300 for fully built diff with gears of your choice and truetrac. That INCLUDES shipping. Just add gear oil, bolt in and go.
 

[whitehumh2]

Sad to say but that whole idea and solution are MY design back in 2006. I made to first one for a buddy out a scrap Dana 44 front diff. We used the CV axles from a suburban.

Oh well, guess I should've patented it!

[yevych]

[quote="Polar Bear"]
Sad to say but that whole idea and solution are MY design back in 2006. I made to first one for a buddy out a scrap Dana 44 front diff. We used the CV axles from a suburban.


Oh well, guess I should've patented it!
[/quote]
 
I wish you did Kev. Do you have any photos of that one?