Canadian Hummer Club Forums

Almsot to answer question for what I used?



All was got from crappy tire, and also that premium bond. For the hole after a replaced metal behind it

Thanks, yea

Well this is how Roy did my new rear quarter panel

This how my piece of crap passenger side looked.

I ended up stripping out the load of bondo, basically saying that everything down to the metal.

The former Body Shop basically filed down the rivets and try to bond over it to make it smooth, looked shity.

Here are some pictures of the progress I made so far,



Lol, didn't realize how many damn rivets alone there are just on the back hahaha

More and more hours of sanding, then the pop rivits everywhere hehe



Then the reassembly part

Oh my, I got you doing it all. How about the back of the cab at fender tops?? 
Looking great ! Keep at it.

Lmao!!!! How the heck did you still remember that?

Honestly I'm planning to play with that this weekend. I have my mind set on completing that whole rear quarter top and bottom before it gets too cold.



This is all thanks to you for giving me the help* knowledge* with the (other side repairs)



Only part the erks me is after a while the pop rivit gun(kick back) ,starts to irritate the carpal....



But yeah if the weather is good I'll smooth that top of back fender out



I'm sure, even if its warm now, winter wants to show quick

I used the larger gun, 2 hand, arms are 18", but still a lot of pumping.

This might be worth the investment if you are planning on doing alot more rivits:
 
https://amzn.to/2ZVnGO2