Throttle body cleaning on H3 Alpha
Posted: Tue Sep 11, 2012 8:03 pm
Ok here we go first clean engine Coweling and remove oil filler cap now lift coweling from front . replace oil cap and clean coweling
what you'll see is this

loosen the hose clamps on airbox ( as you would to change air filter) and at front of engine. now unplug pvc valve hose from bos ( 9 o'clock position on photo) it just pulls out. lift out black plastic air intake unit and clean its outside.
from the front the engine looks like this( top nuts have been removed)

pull small grey clip on airbox side of throttle body and check plug for other locks and disconnect wiring plug.
now using 10mm socket or wrench remove two nuts from top and two bolts from bottom of throttle body and carefully remove unit (TAKE care not to damage green ring seal gasket)engine now looks like this.

now take unit and place on paper towels ( over newspapers is recomended).rubber gloves are recommended
use cleaner as per instructions do both sides. a small brush may help and towel out deposits. it may take several trys donot force butterfly open be carefull.
what you'll see is this

loosen the hose clamps on airbox ( as you would to change air filter) and at front of engine. now unplug pvc valve hose from bos ( 9 o'clock position on photo) it just pulls out. lift out black plastic air intake unit and clean its outside.
from the front the engine looks like this( top nuts have been removed)

pull small grey clip on airbox side of throttle body and check plug for other locks and disconnect wiring plug.
now using 10mm socket or wrench remove two nuts from top and two bolts from bottom of throttle body and carefully remove unit (TAKE care not to damage green ring seal gasket)engine now looks like this.

now take unit and place on paper towels ( over newspapers is recomended).rubber gloves are recommended
use cleaner as per instructions do both sides. a small brush may help and towel out deposits. it may take several trys donot force butterfly open be carefull.