1993 H1 four door soft top
Posted: Wed Apr 06, 2016 4:18 pm
Originally started life, i believe from cross-referencing the VIN, as a recruit two door model, previous owner installed a cummins BT4, X-doors, and the soft top for a limited time or while it lasts, purchase includes a 2000 wagon roof.
The truck does need a little work here and there. With the 3L80 it is a bit sluggish until the RPMs get up.. From Cummins BT4 conversionists, I hear that the 700R4 with Np241 is a better combination.
This unit has a cummins recon engine which runs like a top, starts quickly every time.
Front drive shaft is disconnected due to the engine being a little low. If I were to keep it I would increase the body lift by 1-2" and raise the engine as well.
I have ordered a cummins fuel solenoid shut off and a thermostatic control and relay for the elec rad fan.
As far as I know at this time it needs:
Alternator
1 CV boot with small tear
1 high back seat
2x rear clearance lenses and drivers front clearance lense
Blow out Price: 21,000 CAD
For a limited time get the 2000 Wagon roof included if you pay full price for the Hummer.
The truck does need a little work here and there. With the 3L80 it is a bit sluggish until the RPMs get up.. From Cummins BT4 conversionists, I hear that the 700R4 with Np241 is a better combination.
This unit has a cummins recon engine which runs like a top, starts quickly every time.
Front drive shaft is disconnected due to the engine being a little low. If I were to keep it I would increase the body lift by 1-2" and raise the engine as well.
I have ordered a cummins fuel solenoid shut off and a thermostatic control and relay for the elec rad fan.
As far as I know at this time it needs:
Alternator
1 CV boot with small tear
1 high back seat
2x rear clearance lenses and drivers front clearance lense
Blow out Price: 21,000 CAD
For a limited time get the 2000 Wagon roof included if you pay full price for the Hummer.
