Outfitter Design HP Dana 44 IFS bolt front diff
Posted: Mon Mar 13, 2017 4:07 pm
Just want to share the awesome Outfitter Design new mods for the H3.
<div>...from the forum:</div>
<div>In regards to the loss of ground clearance there are three options:</div>
<div>#1 Run the 0.75" spacers in the kit</div>
<div>#2 Notch the skid just where diff comes in contact (will be close to flush with bottom of skid plate)</div>
<div>#3 We will make a 1/4" plate skid which will fit up tight to the diff and should be almost no loss of ground clearance. </div>
~$3,300 for fully built diff with gears of your choice and truetrac. That INCLUDES shipping. Just add gear oil, bolt in and go.
<div>...from the forum:</div>
<div>In regards to the loss of ground clearance there are three options:</div>
<div>#1 Run the 0.75" spacers in the kit</div>
<div>#2 Notch the skid just where diff comes in contact (will be close to flush with bottom of skid plate)</div>
<div>#3 We will make a 1/4" plate skid which will fit up tight to the diff and should be almost no loss of ground clearance. </div>
~$3,300 for fully built diff with gears of your choice and truetrac. That INCLUDES shipping. Just add gear oil, bolt in and go.