Re: Powder coat or Paint??
Posted: Sat Jul 11, 2009 10:31 am
not chrome on mine, I got an extra set of the OEM brushed aluminum and then went to town on them.. after washing, sanding, washing, sanding, 4 time each, then I used a "wax/grease remover" from Duplicolor and washed again. I then started inside on the back of the rim, 3 coats of Duplicolor Black Primer, the one very light coat of Rubberized rocker panel guard, then 2 coats of Duplicolor High Heat engine Paint, then 2 coats of Clear..then I washed and wiped down the front, outside oof the RIM and started over but this time i did 4 coats of primer, again a light coat of rubberized rocker panel guard, then 4 coats of Engine High Heat enamel paint, and 3 coats of Clear coat..
took lots of time but I let the RIMS bake in the HOT HOT sun in between coats...I am happy, truly happy with the results and the cost, total invested is $90 in material, my time is not counted, about 6 hours of work...but..take a look!
Before
[img width=500 height=375]http://i248.photobucket.com/albums/gg17 ... CN6756.jpg[/img]
After
[img width=500 height=375]http://i248.photobucket.com/albums/gg17 ... CN4602.jpg[/img]
took lots of time but I let the RIMS bake in the HOT HOT sun in between coats...I am happy, truly happy with the results and the cost, total invested is $90 in material, my time is not counted, about 6 hours of work...but..take a look!
Before
[img width=500 height=375]http://i248.photobucket.com/albums/gg17 ... CN6756.jpg[/img]
After
[img width=500 height=375]http://i248.photobucket.com/albums/gg17 ... CN4602.jpg[/img]