Page 8 of 11
Re: December Alberta Meet & Greet
Posted: Sun Dec 12, 2010 10:32 pm
by Khamul
10 bucks says B-man is going to show up with a custom sheet-metal 4 seater polished smoother than a baby's bottom, with an onboard bar and stereo system!!!!
I think I'll take out a policy and call dibs on seat 4!!!
Re: December Alberta Meet & Greet
Posted: Mon Dec 13, 2010 9:44 am
by Khamul
Re: December Alberta Meet & Greet
Posted: Mon Dec 13, 2010 7:45 pm
by Khamul
Crap - I may be out for this Saturday unless I can get prts on time.... need a new driveshaft U-Joint.....
Re: December Alberta Meet & Greet
Posted: Mon Dec 13, 2010 7:45 pm
by Khamul
Crap - I may be out for this Saturday unless I can get prts on time.... need a new driveshaft U-Joint.....
Re: December Alberta Meet & Greet
Posted: Mon Dec 13, 2010 7:54 pm
by brianwidahl
ya i did get it dave thanks
im meeting up with roadworrier on wednesday to pick the carrier up.
oh oh we can definatly get you parts on time.
let me know if you need a hand one of these nights, shouldnt take long
Re: December Alberta Meet & Greet
Posted: Tue Dec 14, 2010 5:53 pm
by Khamul
Success Baby Yeah!!!!!
My @ss is freezing though but ma baby lives!!!!
Re: December Alberta Meet & Greet
Posted: Tue Dec 14, 2010 6:05 pm
by brianwidahl
sweet
i have to change a my muffler and a tensioner pulley before the weekend
Re: December Alberta Meet & Greet
Posted: Tue Dec 14, 2010 7:08 pm
by Khamul
Magnaflow Baby!!
Let me know if you need any help as I helped with Gary's Tensioner and it went well...
Re: December Alberta Meet & Greet
Posted: Tue Dec 14, 2010 7:15 pm
by brianwidahl
totally
rick ordered me the same one you have.
get it put in tomorrow.
as far as the tensioner it should be a quick fix
then its ready to rock
Re: December Alberta Meet & Greet
Posted: Tue Dec 14, 2010 10:10 pm
by Khamul
Awesome!!!
You'll be louder than me for sure as I had Rick put back in high flow Cats as it was just a wee bit too loud for my taste... Of course it did a nice job drowning out the kids!
Tensioner was easy...... only tricky part was getting that belt on the final loop....